X
Vehicles without ATA: press and hold the
& button on the remote control/multi-
function key for approximately 2 seconds
.
or
X
Vehicles with ATA: press the & button
on the remote control/multifunction key.
All
turn signals flash three times. The doors
are locked. The side windows and the slid-
ing sunroof/pop-up roof close.
i
The roof hatch is not closed.
If there is a risk of becoming trapped:
X
Turn the integrated key to position 1
immediately
and hold it there until the side
windows and the sliding sunroof/pop-up
roof open again.
or
X
Press and hold the % button of the
remote
control/multifunction key until the
side windows and the sliding sunroof/pop-
up roof open again.
The driver's door is unlocked.
X
Convenience opening: insert the integra-
ted
key into position 2 in the driver's door
lock, then turn it to position 1 and hold it
there.
or
X
Press and hold the % button on the
remote
control/multifunction key until the
side windows and the sliding sunroof/pop-
up roof have reached the desired position.
All turn signals flash once. The driver's door
is unlocked. The side windows and the slid-
ing sunroof/pop-up roof open automati-
cally.
i
The roof hatch is not opened.
ATA (anti-theft alarm system)
General notes
ATA protects the vehicle from break-in and
theft.
ATA monitors:
R
on the tractor vehicle:
-
the doors
-
the exterior flaps
-
the power supply
-
the cab tilt lock
-
the vehicle interior (can be deactivated)
-
the maintenance flap
R
the box-type bodies
Vehicles for the transport of hazardous
goods:
if ATA is primed and the power supply
is interrupted using the battery isolator
switch (Y page 111), the alarm is triggered.
The on-board computer displays an according
message in an event window.
Bear the following in mind:
R
When ATA is primed, it confirms the locking
procedure by flashing all turn signals three
times. If the turn signals do not flash three
times, one or more components are not in
the rest position. ATA cannot then monitor
these components, e.g. open exterior flaps.
R
Components that are moved to the rest
position within approximately 30 seconds
of ATA being primed will be monitored.
R
If you subsequently close the exterior flaps
and want to include them in the monitoring,
prime ATA again.
ATA alarm
If ATA triggers an alarm:
R
all turn signals flash for approximately
5 minutes and
R
the alarm siren sounds for approximately
30 seconds
If you turn the ignition lock to the drive posi-
tion
after an alarm has been triggered, the on-
board computer displays the alarm trigger
data along with the date and time in an event
window.
66
Locking system
Opening and closing
To Next Page
Loading...
Need help?
General
