X
Pull loop = on co-driver's seat :.
The co-driver seat backrest is unlocked.
X
Fold down the backrest.
Before using the bed during a journey, make
sure
you take notice of the legal requirements
for the country you are currently in. If you use
the bed while the vehicle is in motion, tighten
the safety net. Information on tightening the
safety net and on setting the head section can
be found in the "Lower bed" section
(Y page 85).
X
To fold down: press bed ? against the
rear wall.
X
Press and hold lock B.
X
Unclip retainer band A from the wall
bracket.
X
Release lock B.
X
Swing bed ? downwards.
X
To fold up: fully lower the head section of
the bed.
X
Fold up bed ? and press against the rear
wall.
X
Press retainer band A
towards lock B and
clip it into the wall bracket.
X
Fold back the seat backrest until it
engages.
Berths in an M cab
Overview
The following berths may be fitted in the M
cab:
R
Standard berth, lower/padded stowage
space (Y page
90)
R
Lower standard berth, split (Y page 91)
Standard berth, lower/padded stow-
age space
G
WARNING
A vehicle occupant on the berth while the
vehicle is in motion cannot be restrained.
There is a risk of injury, possibly even fatal.
Only use the berth when the vehicle is sta-
tionary.
!
Make
sure that the berth does not hit the
seats when you fold it up or down. Swing or
fold the backrests of the driver's and co-
driver's seats forward or adjust the seats
further forward. The berth can otherwise hit
the seats and damage both components.
Berths (example: standard berth, lower)
X
Vehicles with standard lower berth: adjust
or fold the driver's and co-driver's seat
backrests forward.
X
If necessary, move the driver's and co-driv-
er's seats sufficiently forward.
X
To fold down: press and hold the berth
against the rear wall.
90
Berths in an M cab
Driver's workstation
To Next Page
Loading...
Need help?
General
