2. Remove the plug from the flush fitting, and attach a water hose. Turn on
the water to half of the maximum flow.
Flush fitting
3. Start the engine and run it at idle speed in neutral shift position.
IMPORTANT: Do not run the engine above idle while flushing.
4. Check for a steady stream of water flowing out of the water pump
indicator hole. Continue flushing the outboard for 3–5 minutes, carefully
monitoring the water supply at all times.
5. Stop the engine, turn off the water, and remove the water hose.
6. Install the plug into the flush fitting.
7. Install the propeller.
Top Cowl Removal and Installation
REMOVAL
1. Release the rear latch.
MAINTENANCE
74 eng
To Next Page
Loading...
Need help?
General
