Throttle drum WOT stop and cable slack
16. Rotate the throttle grip to WOT and back to idle several times, checking to
ensure the throttle drum stop is contacting the bracket stop.
17. After the cables are adjusted correctly, apply 2‑4‑C with PTFE onto the
exposed cables, including the cable barrel and throttle drum guide.
Tube Ref
No.
Description Where Used Part No.
95
2-4-C with PTFE Throttle cables 92-802859A 1
18. Align the cowl egress grommet, install the driveshaft housing cover, and
secure the cowl with the screws. Tighten the screws to the specified
torque. Refer to Driveshaft Housing Cover Removal and Installation.
Description
Nm lb‑in. lb‑ft
Driveshaft housing cover screws 6 53
Battery Installation ‑ Electric Start Models
MOUNTING BATTERY
Follow the battery manufacturer's instructions carefully. Mount battery in the
boat so it is secured against movement, preferably in a battery box. Make sure
battery is equipped with a nonconductive shield to prevent accidental shorting
of battery terminals.
NOTE: Electric starting outboards must have the battery cables connected to a
battery whenever the engine is running, even if started manually, as damage to
the charging system could result.
ENGINE INSTALLATION
eng 127
To Next Page
Loading...
Need help?
General
