8. Install the propeller, rear thrust washer, and propeller nut onto the shaft.
9. Place a block of wood between the gearcase and the propeller to prevent
rotation and tighten the propeller nut to the specified torque.
NOTE: If the propeller nut doesn't align with the propeller shaft hole after
tightening, tighten the nut further to align with the hole.
10. Align the propeller nut with the propeller shaft hole. Insert a new cotter pin
in the hole and bend the ends.
a - Cotter pin
b - Propeller nut
c - Rear thrust washer
d - Front thrust hub ‑ Larger diameter end towards propeller
Description Nm lb‑in. lb‑ft
Propeller nut 12 106.2 –
Fuse Replacement ‑ Electric Start Models
IMPORTANT: An ATC fuse has the fuse element enclosed or sealed inside the
plastic housing. This type of fuse must be used for marine applications. Marine
applications are exposed to environments that may have the potential to
accumulate explosive vapors. ATO fuses have exposed elements and should
never be used in marine applications.
NOTE: Both fuse holders have a space for a spare fuse. Always carry spare
fuses.
To Next Page
Loading...
Need help?
General
