MAINTENANCE
92
OIL FILLING
IMPORTANT: Do not try to fill the oil level to the top of the operating
range (upper hole). Oil level is correct as long as it appears in the
operating range between the upper and lower hole.
1. Position the outboard in a level operating position.
2. Remove the oil fill cap and add the recommended oil to the
midpoint (middle hole) of the oil level operating range. Adding
approximately 1.0 liter (1.1 U.S. quart) of oil will bring the oil
level to the midpoint of the oil level range. Reinstall the oil fill
cap.
a - Oil level operating range
b - Midpoint
c - Dipstick
d - Oil fill cap
3.
Idle engine for five minutes and check for leaks. Stop the
engine and check the oil level on the dipstick. Add oil if
necessary.
Lubrication Points
1. Lubricate the following with Quicksilver or Mercury Precision
Lubricants 2‑4‑C with Teflon or Special Lubricant 101.
Tube Ref No. Description Where Used Part No.
34
Special Lubricant 101
Swivel bracket,
transom clamp
screws, tilt tube,
propeller shaft,
steering cable grease
fitting
92-802865Q0
2
To Next Page
Loading...
Need help?
General
