Mercury 2.8 Diesel User Manual

Section 4 - Maintenance
Page 60 90-8M0113987 eng DECEMBER 2015
5. Remove the drain plug, or fitting (if equipped), from the aft end cover of the engine oil cooler.
Typical engine
a - Engine oil cooler
b - Drain plug, or fitting if equipped
NOTE: In the following steps, the hoses may require lowering or bending to allow seawater to drain completely.
6. Disconnect the seawater inlet hose from the connector on the seawater pump hose and drain.
2.8
4.2
a - Seawater inlet hose
b - Connector
c - Seawater pump hose
7. Repeatedly clean out the drain holes using a stiff piece of wire until the seawater section is completely drained.
8.
On models equipped with a seawater strainer:
a. Remove the drain plug and washer if equipped.
b. Remove both hoses from the seawater strainer and drain them completely.
c. Drain and empty the seawater strainer.
d. Connect the hoses and tighten the hose clamps.
a
b
23295
a
b
23480
c
a
b
c
b
a
23649

Mercury 2.8 Diesel Specifications

General

Brand	Mercury
Model	2.8 Diesel
Category	Engine
Language	English