MAINTENANCE
112 eng
2. Attach a water hose to the fitting. Turn on the water and
flush for 3 to 5 minutes.
Top Cowl Removal and Installation
REMOVAL
1. Release the front and side cowl latches.
2. Lift the top cowl from the outboard.
INSTALLATION
1. Position the top cowl over the engine.
2. Ensure the bottom rubber seal fits properly and lock the
front and side latches.
Cleaning Care for Top Cowl
IMPORTANT: Dry wiping (wiping the plastic surface when it is
dry) will result in minor surface scratches. Always wet the
surface before cleaning. Follow the cleaning and waxing
procedure.
CLEANING AND WAXING PROCEDURE
1. Before washing, rinse the top cowl with clean water to
remove the dirt and dust that may scratch the surface.
2. Wash the top cowl with clean water and a mild non‑abrasive
soap. Use a soft clean cloth when washing.
3. Dry thoroughly with a soft clean cloth.
To Next Page
Loading...
Need help?
General