FEATURES AND CONTROLS
70 eng
Dual Handle Console Control with CAN Trackpad
Features and Operation
DUAL-HANDLE CONSOLE CONTROL WITH CAN
TRACKPAD: FEATURES AND OPERATION
1. Operation of shift and throttle is controlled by the movement
of the control handle. Push the control handle forward from
neutral to the first detent for forward gear. Continue pushing
the handle forward to increase speed. Pull the control
handle back from neutral to the first detent for reverse gear.
Continue pulling the handle back to increase speed.
F
N
R
3417
2. Trim switch (if equipped) ‑ Pressing the trim switch allows
the engine to trim up and down.
N
E
U
T
R
A
L
SYNC
THROTTLE
ONLY
+
-
TROLL
TRANSFER
DOCK
1 LEVER
22132
3. Neutral lights ‑ The neutral lights illuminate when the engine
is in neutral gear position. The lights will flash when the
engine is in throttle only mode.
NOTE: Gear position is determined by the position of the shift
actuator on the engine, not the position of the control handle.
To Next Page
Loading...
Need help?
General