FEATURES AND CONTROLS
eng 83
3. Press throttle only/station select button two times. The
"ACTIVE" light will illuminate to indicate the remote control is
in control of the engine.
a - Active light
b - Throttle only/station select button
4. The "ACTIVE" light will switch off at the original helm.
Synchronizing Helms Prior to Helm Transfer
Pressing the throttle only/station select button one time allows
the boat operator 10 seconds to match up the control handle
setting at the new station with the handle setting that is at the old
(to be inactive) station. If the handle is not matched, the neutral
light will flash. The light blinks faster as the handle is nearing
match position. Once the light stays on continuously, the handle
is matched and the throttle only/station select button can be
pressed again to complete the transfer. This completes the
transfer process, and give control to the new station. If the helm
transfer is not completed within 10 seconds, the helm transfer is
cancelled.
Shadow Mode Control with CAN Trackpad
Features and Operation
TRIPLE ENGINE THROTTLE AND SHIFT OPERATION
Movement of the handles on the remote control allows the boat
operator to control the engine throttle speed and gear shift
positions of all three engines.
The throttle and shift function is dependant on what engines are
running. Refer to the following table.
ACTIVE
STATION SELECT
ACTIVE
SYNC
STAT ION SELECT
THROTTLE
ONLY
THROTTLE
ONLY
22753
a
b
a
b
To Next Page
Loading...
Need help?
General