200/225/250/275 VERADO 4-STROKE
Page 2 / 51 90-10238051
Lubricant, Sealant, Adhesives
Tube Ref No. Description Where Used Part No.
Anti-Corrosion Grease Propeller shaft splines 92-802867A1
2-4-C Marine Lubricant with Teflon Propeller shaft splines 92-802859A1
Notice to Installer
This Product Requires Electronic Calibration Before Use.
Installation of this product will require electronic calibration. This calibration must not be
attempted by anyone other than the Original Equipment Manufacturer (OEM) or a
Mercury technician trained in Digital Throttle and Shift systems (DTS) at an authorized
Mercury dealership. Improper installation and calibration of the DTS product will result in
a system which is inoperable or unsafe for use.
Avoiding Loss of Throttle and Shift Control
WARNING
To avoid the possibility of serious injury or death from loss of boat control, do not splice
or probe into any wire insulation of the DTS system. Splicing or probing will damage
the wire insulation allowing water to enter the wiring. Water intrusion may lead to wiring
failure and loss of throttle and shift control.
Accessory Electric Fuel Pump/Fuel Line Primer Bulb
IMPORTANT: Do not install either an accessory electric fuel pump or a fuel line primer
bulb into the fuel system of this engine.
Avoiding Fuel Flow Restriction
IMPORTANT: Adding components to the fuel supply system (filters, valves, fittings, etc.)
may restrict the fuel flow. This may cause engine stalling at low speed, and/or a lean fuel
condition at high RPM that could cause engine damage.
Boat Horsepower Capacity
WARNING
Using an outboard that exceeds the maximum horsepower limit of a boat can: 1) cause
loss of boat control 2) place too much weight at the transom altering the designed
flotation characteristics of the boat or 3) cause the boat to break apart particularly
around the transom area. Overpowering a boat can result in serious injury, death or
boat damage.
To Next Page
Loading...
Need help?
General
