To Next Page

To Previous Page

1. Turn ignition to the ON position.

2. Start the engine.

3. Press the INFO button repeatedly until the Compass and Odometer

are displayed. (Do not select Trip, DTE, or AFE. The top of the message

center must be blank).

Note: If message center displays the message ⬙SLOW CIRCLES TO

CALIBRATE⬙, then perform the CALIBRATION PROCEDURE.

4. Determine your magnetic zone by

referring to the zone map.

5. Press and hold the RESET until

the message center display changes

to show the current zone setting.

6. Release the RESET control, then

slowly press RESET down again.

7. Press the SETUP control

repeatedly until the correct zone

setting for your geographic location

is displayed on the message center. To exit the zone setting mode press

and release the RESET control.

8. If necessary, press the RESET control to start the compass calibration

function.

Compass calibration adjustment

Perform the following steps on an open area free from steel structures

and high voltage lines. For optimum calibration, turn off all electrical

accessories (heater / air conditioning, wipers, etc.) and make sure all

vehicle doors are shut.

1. Turn ignition to the ON position.

123

6 7 8 9 1011

2006 Montego (mgo)

Owners Guide (post-2002-fmt)

USA (fus)

Driver Controls

Mercury 2006 Montego User Manual

Questions and Answers: