OPERATION
49
Pre‑Starting Check List
• Operator knows safe navigation, boating, and operating
procedures.
• An approved personal flotation device of suitable size for each
person aboard and readily accessible (it is the law).
• A ring type life buoy or buoyant cushion designed to be thrown
to a person in the water.
• Know your boats maximum load capacity. Look at the boat
capacity plate.
• Fuel supply OK.
• Ensure the boat drain plug is installed.
• Arrange passengers and load in the boat so the weight is
distributed evenly and everyone is seated in a proper seat.
• Tell someone where you are going and when you expect to
return.
• It is illegal to operate a boat while under the influence of
alcohol or drugs.
• Know the waters and area you will be boating; tides, currents,
sand bars, rocks, and other hazards.
• Make inspection checks listed in Maintenance ‑ Inspection
and Maintenance Schedule.
• Check steering for free operation.
• Check for debris around the rudder and reverse gate which
may jam or hinder operation.
• Before launching, examine the jet drive water intake for
obstructions which may prevent pumping of water.
• Ensure the driveshaft bearing on the jet drive is lubricated.
Operating In Freezing Temperatures
If there is a chance of ice forming on the water, the jet drive should
be removed and drained completely of water. If ice should form at
the water level inside the outboard driveshaft housing, it will block
water flow to the engine causing possible damage. Do not start the
engine until the ice is clear.
To Next Page
Loading...
Need help?
General
