CARBURETOR
90-857138R1 MAY 2000 Page 3B-7
Carburetor Removal and Installation
REMOVAL
1. Disconnect fuel supply from engine.
2. Remove the rewind starter.
3. Disconnect the fuel hose and breather hose.
4. Remove the two bolts securing the flame trap and carburetor to the intake manifold.
5. Disconnect the choke cable and throttle linkage from the carburetor. Remove carbure-
tor.
INSTALLATION
1. Reconnect the choke cable and throttle linkage.
2. Install the carburetor as shown.
3. Reinstall the fuel hose and breather hose. Fasten the fuel hose with a hose clamp.
Carburetor Mounting Bolts Torque
70 lb-in. (8 Nm)
a
b
c
d
e
f
g
h
b
k
j
l
j
i
a-Fuel Hose
b-Hose Clamp (2)
c-Breather Hose
d-Bolt (2) M6 x 85 mm
e-Flat Washer (2)
f-Collar (2)
g-Choke Cable
h-Air Silencer
i-Insulator Gasket
j-Gasket
k-Intake Manifold
l-Throttle Linkage
To Next Page
Loading...
Need help?
General
