GENERAL INFORMATION
9
Do not overpower or overload your boat. Most boats will carry a required capacity plate indicating the
maximum acceptable power and load as determined by the manufacturer following certain federal
guidelines. If in doubt, contact your dealer or the boat manufacturer.
High-Speed and High-Performance Boat Operation
If your outboard is to be used on a high-speed or high-performance boat with which you are unfamiliar,
we recommend that you never operate it at its high speed capability without first requesting an initial
orientation and familiarization demonstration ride with your dealer or an operator experienced with your
boat/outboard combination. For additional information, obtain a copy of our Hi-Performance Boat
Operation booklet from your dealer, distributor, or Mercury Marine.
Outboard Remote Control Models
The remote control connected to your outboard must be equipped with a start in neutral only protection
device. This prevents the engine from starting when the shift is actuated in any position other than neutral.
!
WARNING
Starting the engine with the drive in gear can cause serious injury or death. Never operate a boat that
does not have a neutral-safety-protection device.
Remote Steering Notice
The steering link rod that connects the steering cable to the engine must be fastened utilizing self-locking
nuts. These self-locking nuts must never be replaced with common nuts (non-locking) as they will work
loose and vibrate off, freeing the link rod to disengage.
To Next Page
Loading...
Need help?
General
