OUTBOARD INSTALLATION
69
Installation Information
BOAT HORSEPOWER CAPACITY
!
WARNING
Exceeding the boat's maximum horsepower rating can cause serious injury or death. Overpowering
the boat can affect boat control and flotation characteristics or break the transom. Do not install an
engine that exceeds the boat's maximum power rating.
Do not overpower or overload your boat. Most boats will carry a required capacity plate indicating the
maximum acceptable power and load as determined by the manufacturer following certain federal
guidelines. If in doubt, contact your dealer or the boat manufacturer.
START IN GEAR PROTECTION
!
WARNING
Starting the engine with the drive in gear can cause serious injury or death. Never operate a boat that
does not have a neutral-safety-protection device.
The remote control connected to the outboard must be equipped with a start in neutral only protection
device. This prevents the engine from starting in gear.
SELECTING ACCESSORIES FOR YOUR OUTBOARD
Genuine Mercury Precision or Quicksilver Accessories have been specifically designed and tested for
your outboard. These accessories are available from Mercury Marine dealers.
IMPORTANT: Check with your dealer before installing accessories. The misuse of approved accessories
or the use of non-approved accessories can damage the product.
Some accessories not manufactured or sold by Mercury Marine are not designed to be safely used with
your outboard or outboard operating system. Acquire and read the installation, operation, and
maintenance manuals for all your selected accessories.
ELECTRIC FUEL PUMP
If an electric fuel pump is used, the fuel pressure must not exceed 27.58 kPa (4 psi) at the engine. If
necessary, install a pressure regulator to regulate the pressure.
To Next Page
Loading...
Need help?
General
