Engine speed: Idling speed after warming up.
In Gear In Neutral
850 RPM 1000 RPM
Starting the Engine
Before starting, read the Prestarting Check List, special operating
instructions, and Engine Break‑In Procedure in this section.
IMPORTANT: Be sure to connect the emergency lanyard to your waist or
clothing. The engine will shut down if the lanyard becomes disconnected from
the engine.
NOTE: The engine will not start unless the lanyard has been properly
connected to the emergency stop switch.
1. Lower the outboard to the run position. Make sure the cooling water
intake is submerged.
NOTICE
Without sufficient cooling water, the engine, the water pump, and other
components will overheat and suffer damage. Provide a sufficient supply of
water to the water inlets during operation.
To Next Page
Loading...
Need help?
General
