MAINTENANCE
102 eng
Assemble steering link rod to steering cable with flat washer and
nylon insert locknut. Tighten locknut until it seats, then back nut
off 1/4 turn.
Assemble steering link rod to engine with bolt, locknut and
spacer and flat washers. Torque locknut to specifications.
Corrosion Control Anode
Your outboard has a corrosion control anode installed to the
gearcase. An anode helps protect the outboard against galvanic
corrosion by sacrificing its metal to be slowly corroded instead of
the outboard metals.
The anode requires periodic inspection especially in salt water
which will accelerate the erosion. To maintain this corrosion
protection, always replace the anode before it is completely
eroded. Never paint or apply a protective coating on the anode
as this will reduce effectiveness of the anode.
Propeller Replacement
!
WARNING
Rotating propellers can cause serious injury or death. Never
operate the boat out of the water with a propeller installed.
Before installing or removing a propeller, place the drive unit in
neutral and engage the lanyard stop switch to prevent the
engine from starting. Place a block of wood between the
propeller blade and the anti‑ventilation plate.
To Next Page
Loading...
Need help?
General
