OPERATION OF THE VALVE
Remove the outside cap. The valve is closed when the middle screw is in the
upside position. Push the valve once to open it. Push the valve again to close
it.
Push to open or close
PUMP CONNECTION
Put the end piece (the part that must be turned) of the pump on the valve. Turn
to the right (clockwise) and start pumping. Keep pumping until the
recommended pressure is reached. When ready, be sure to remove the pump.
Be sure to put on the protection cap again (for protection from dirt and
damage).
a - To the valve
b - To the air pump
OPERATION
eng 31
To Next Page
Loading...
Need help?
General