• Keel chamber (if applicable). Always inflate the keel chamber last.
How to Inflate Your Quicksilver Boat
1. Inflate the chamber with the inflating/deflating valve.
2. For the remaining chambers, put in enough pressure to allow the boat to
spread out, but do not fully inflate the tube.
3. Pump the chamber with the inflating/deflating valve until it starts leaking
air
4. Pump the remaining chambers in right order until the inflating/deflating
valve starts leaking again. If inflation is done in the right order, the boat
has the correct pressure and there is no distortion of fabric near the
bulkheads
IMPORTANT: Never exceed these values.
• Inflate the boat to 0.25 bar = 3.6 psi
• Inflate the keel to 0.4 bar
• Inflate the high‑pressure bottom to 0.8 bar
NOTICE
Avoid structural damage due to overinflation. Never leave an inflatable boat
in direct sunlight, unless the boat is in the water. The heat from direct sunlight
can cause the air in the chambers to expand, resulting in damage to the boat.
OPERATION
38 eng
To Next Page
Loading...
Need help?
General