e. Starting at one of the air valves, inflate each air chamber in turn,
inflating only a quarter of the way full. Repeat this procedure to evenly
fill the air chambers until the air chambers are filled to the
recommended air pressure of 0.25 bar (3.6 psi).
2. Unscrew the valve cap from the keel air chamber valve by turning a
quarter of a turn counterclockwise.
a. Ensure that the valve stem is in the closed position.
b. Attach the air hose adapter to the air valve.
c. Inflate the keel to the recommended air pressure of 0.25 bar (3.6 psi).
3. After inflation, install the valve caps tight (turn clockwise).
NOTE: Always be aware of the air pressure in the air chambers. The air volume
inside the air chambers will expand as the internal air temperature rises; this
will cause the air pressure to fluctuate depending on water temperature and
weather conditions. A boat that is correctly inflated may experience a drop in air
pressure and require additional air when temperatures decrease; or it may
become over inflated when in direct sunlight or as the temperatures increase.
This will require the air chamber to be deflated until the recommended air
pressure is reached.
Assembly and Disassembly
FLOORBOARD
Quicksilver inflatable boats that are equipped with an inflatable or a
non‑inflatable floorboard must be operated only with these floorboards properly
installed. Using the boat without a provided floorboard is unsafe,
uncomfortable, and might result in damage to the boat. Refer to Floorboard
Installation.
VALVES
The Quicksilver inflatable valves are especially designed for safe and
comfortable use. The valves are designed flat to increase the comfort in the
boat and to prevent damage to the boat.
OPERATION
34 eng
To Next Page
Loading...
Need help?
General