9. FAULT - IGNITION: A problem has developed in the ignition
system.
10.BATTERY: The electrical system is not charging or the battery
charge is low.
11.ENGINE DATA BUS: The data communication link between
the tachometer and engine is not connected.
12.FAULT - SENSOR: One of the sensors is not functioning
correctly.
13.FAULT - WATER TEMP: The sensor for measuring outside
lake/sea water temperature is not functioning correctly.
14.NO STARBOARD ENGINE: The instrument does not detect
the starboard engine computer. This usually indicates that no
data is being transferred from the engine's computer to the
gauge. Check the wiring. Make sure both terminator resistors
are installed in the bus. Make sure both ECMs are not
configured for the port location using a DDT or Quicksilver
Diagnostic Tool.
15.MULTIPLE STARBOARD ENGINE: SmartCraft gauges are
recognizing multiple engines as starboard.
NOTE: In multiple engine applications, each engine must first be
assigned a position (starboard, port, starboard2 or port2) with a
Computer Diagnostic Tool (CDS) before the system will function
properly.
16.OIL TEMPERATURE: The engine oil is overheating.
To Next Page
Loading...
Need help?
General
