Mercury SC1000 User Manual

SPEEDOMETER CALIBRATION
25
2. Press the "-" or "+" button to select the option choice displayed
in the [ ] brackets on the screen.
3. Press "MODE" ["SAVE"] to save the setting and advance
through the calibration selections.
EXTERNAL SENSORS
(SKIP) (EDIT)
23569
CALIBRATION 2
EXTERNAL SENSORS
Selects and calibrates external sensors that are
installed in the system. Select [SKIP] for to
proceed to the next selection. Select [EDIT] to
proceed to external sensor selection.
(SAVE) ( YES )
23574
CALIBRATION 2
EXTERNAL SENSORS
( NO )
AIRTEMP ?
YES
Is an air temperature sensor installed? Press "-"
to select no or "+" to select yes.
(SAVE) ( YES )
23582
CALIBRATION 2
EXTERNAL SENSORS
( NO )
GPS ?
YES
Is a GPS sensor installed? Press "-" to select no
or "+" to select yes.
(SAVE) ( YES )
23596
CALIBRATION 2
EXTERNAL SENSORS
( NO )
USE GPS SPEED ? YES
Use the GPS input to drive the speed display?
Press "-" to select no or "+" to select yes.
(SAVE) ( UP )
23592
CALIBRATION 2
SEA TEMP
(DOWN)
OFFSET = 0 F
Adjust the water temperature sensor to correct
display readings that are too high/low. Press "-"
or "+" to calibrate the temperature display down
or up.
(SAVE) ( YES )
23617
CALIBRATION 2
TROLL CONTROL ?
( NO )
ENABLED
To enable troll control select "YES" to disable
select "NO".
(SAVE) ( YES )
23618
CALIBRATION 2
( NO )
EXIT ?
Press "MODE" to exit. Press "-" to go to the start
of CAL 2. Press "+" to continue to CAL 1.

Mercury SC1000 Specifications

General

Brand	Mercury
Model	SC1000
Category	Measuring Instruments
Language	English