Mercury SMARTCRAFT Wiring Connections

SMARTCRAFT DEPTH TRANSDUCER WIRING CONNECTIONS
Page 2 / 5
90-8M0063595 DECEMBER 2011
2. Push each wire terminal into its respective position in the wire retainer until they snap in place.
3. Assemble the wire retainer securely into the connector.
a - Wire retainer
b - Wire terminal
c - Connector
d - Assembled components
e - Transducer connector
f - Temperature/speed sensor connector
Depth Transducer Engine Connections for Verado, OptiMax, MerCruiser with
a 4 Pin Engine Diagnostic Test Connector
1.
Locate the engine diagnostic test connector on the engine. Refer to the appropriate service manual.
a. If a depth transducer is installed, disconnect the transducer cable from the engine diagnostic test connector.
a - Engine diagnostic test
connector
b - Transducer cable connector
b. For a new installation, disconnect the weather cap from the engine diagnostic test connector.
2. Connect the diagnostic fuse harness to the engine diagnostic test connector. Refer to the installation instructions with the
diagnostic fuse harness.
c
b
a
PUR
A B C D
A B C D
d
WHT
BLU
BLK
e
c
b
a
GRN
A B C D
A B C D
d
WHT
RED
BRN
f
34123
C - WHT
D - RED
A - BLK
B - DRK BLU
22554
a
b

Mercury SMARTCRAFT Specifications

General

Brand	Mercury
Model	SMARTCRAFT
Category	Boating Equipment
Language	English