SMARTCRAFT DEPTH TRANSDUCER WIRING CONNECTIONS
Page 4 / 5
90-8M0063595 DECEMBER 2011
5. Connect the vessel harness to the engine harness vessel connector.
a - Engine harness vessel connector
b - Engine diagnostic test connector
c - Diagnostic fuse harness
d - Fuse cover
e - 2 amp fuse
f - Transducer cable
g - Vessel harness
h - Fuel 1 sender connector
i - Fuel 2/other sender connector
j - Temperature/speed sensor connector
k - Triducer (reference)
Depth Transducer Engine Connections for OptiMax with a 2 Pin Engine
Diagnostic Test Connector
1.
Locate the engine diagnostic test connector on the engine. Refer to the appropriate service manual.
2. Connect the adapter harness to the engine diagnostic test connector.
3. Connect the black wire with the ring terminal into the black wire on the adapter harness.
4. Locate an engine ground connection within reach of the black wire ring terminal. Secure the ring terminal to the engine
ground connection. Apply Liquid Neoprene to the engine ground connection to prevent corrosion.
Tube Ref No. Description Where Used Part No.
25
Liquid Neoprene Adapter harness ring terminal ground connection 92- 25711 3
FUEL 1
FUEL 2 /
OTHER
a
b
c
d
e
f
g
h
i
j
34124
k
PADDLE WHEEL
SEA TEMP
To Next Page
Loading...
Need help?
General
