OPERATING INSTRUCTIONS
Special functions
Improving the quality of indoor air is one of the purposes of an air conditioner. This air
conditioner is equipped with ionizer or Plasma Dust Collector(Depending on specific
configuration of the model). With the anions generated by Ionizer, the air circulation
of the air conditioner fills the room with refreshing, natural and healthy air. The Plasma
Dust Collector generates a high voltage ionization zone, through which the air is
converted to plasma. Inside the air most of the dust, smoke, and pollen particles are
captured by the electrostatic filter.
CLEAN AIR function(on some models)
Function used after the shut down of cooling operation to clean the Evaporator
,it keeps the air fresh for the next operation.
For cooling models, the unit will operate under FAN ONLY mode
at LOW fan speed for half an hour, and then turn off automatically.
For cooling & heating models, the unit will operate as in the below sequence :
FAN ONLY mode at Low fan speed--Heating operation with LOW fan speed
---FAN ONLY operation--Stop Operation---Turn off.
Note:
This function is only available under COOL(AUTO COOL, FORCED COOL) and
DRY mode.
Before selecting the function, it is recommended to run the air conditioner under
all TIMER setting will be cancelled.
During SELF CLEAN operation, when pressing the SELF CLEAN button on the remote
controller again,the unit will stop the operation and turn off the unit automatically.
Refrigerant Leakage Detection
With this new technology, the dipsplay area will appear EC (if applicable) and the LED
indication lamps continue flashing when the outdoor unit detects refrigerant leakage.
When turns off the unit on COOL, DRY, AUTO (Cool) mode, the air conditioner will continue
operating for about 7-10 minutes (depending on models) with soft wind.This will help to
dry up the condensed water inside the evaporator, and prevent the breeding of mildew.
Under Anti-mildew operation, do not restart the air conditioner until the unit iscompletely off.
,
,
Within the scope of safety angle, it will memorize the open angle of horizontal louver.
If it exceeds, it will memorize the boundry of safety angle. In the following circumstances,
it will return to standard angle: 1) pressing the turbo or manual control button, 2)unplug
and then plug in the machine.
So we strongly suggest that the open angle of the horizontal
louver should not be set too small, in case the condensed water forms and drops from the
horizontal louver.
4
cooling operation for about half an hour. Once the Self Clean function is activated,
(Optional):
Louver Angle Memory Function
SELF CLEAN function
(Optional):
(Optional):
Anti-mildew function
To Next Page
Loading...
Need help?
General
