Installation of drain hose
1. Completely sleeve the drain hose over the water outlet.
2. Fix and tighten it with the spinning clamper.
( As shown in the figure )
INSTALLATION
9
Installation Area
Before installing the machine, the location characterized
follows shall be selected:
1.Rigid, dry, and level surface
2.Avoid direct sunlight
3.Sufficient ventilation
4.Room temperature is above 0 C
5.Keep far away from such as coal or gas
as
fuel sources
Unpacking The Washing Machine
1. Remove the cardboard box and styrofoam packing.
2. Lift the washing machine and remove the base packing.
3. Remove the tape securing the power supply cord and
drain hose.
4. the inlet hose from the drum.Pick up
•
•
the
Stability is important to prevent the product
from !
Make sure that the product not stand on
power cord.
moving
dose
Warning!
•
be
•
Packaging material (e.g. Films, Styrofoam) can
dangerous for children.
There is a risk of suffocation ! Keep all packaging
well away from children. materials
Warning!
w
w
W> 20mm
To Next Page
Loading...
Need help?
General