Product Function Description
Botton Function Description
1.Temperature adjustment button: 70-80-90-100-40-60 cycle setting
temperature;
2.Press start directly after power-on. By default, 100
is turned on and off,
light 1, and start key light is on.
3.Press the heat preservation key once, heat preservation mode 1: heat
preservation after boiling water setting temperature; light 1 + 2, heat
preservation key light (it is suggested to change into heat preservation
before lighting).
4.Press the heat preservation key twice, heat preservation mode 2: after
boiling water to 100 , wait for cooling to set temperature for heat preser-
vation; light 1 + 2 + 3, heat preservation key light (suggested to be
8
Standby and temperature setting state (that is to say, display the set
temperature), press the power button (Start) to start boiling water, boiling
water to 100
, then enter the heat preservation state, and buzzer calls 3
times. In the process of heat preservation, the temperature should be
maintained after cooling down to the set temperature, and the set
temperature should be maintained (1.0L-1.7L, +3/-3
, 1.0L-0.5L (exclud-
ing 1.0), +5/-5
) after 60 +2/-2 minutes, the machine will be shut down.
(Temperature control and thermal insulation keys in no sequence)
6.Note 1: In standby state, the operation of "temperature selection" or "heat
preservation mode setting" key enters the temperature setting state (i.e.
display the setting temperature). If the "Start" key is operated in 3S, the
user-set boiling function will be activated. If the "Start" key is not operated
in 3S, the machine will return to the non-temperature setting state (i.e.
display the actual temperature). The "Start" key is operated in this state,
and the boiling water can be directly activated to 100
.
7.Note 2: When the heat preservation mode is set to 1 or 2, then the setting
temperature can be adjusted by setting key. The adjustment range can
only be adjusted between 70-80-90-40-60.
To Next Page
Loading...
Need help?
General
