Botton Function Description
9
Cleaning
Note
To prolong the kettle's life, please clean the mineral deposits in the kettle
regularly.
Always unplug from the plug socket and allow to cool down before cleaning.
Do not use chemical, steel wool, or abrasive cleaners to clean the outside
of the kettle, as these will scratch the surface and fade the outside color.
1. Fill the kettle with 0.5L white vinegar and the remainder with water and
allow to stand for over 1 hours ;
2. Empty the solution from the kettle. Wipe off the deposits remained with
damp cloth
3. Fill the kettle with clean water, bring to boil and then discard the water.
Repeat and the kettle will be ready to use;
4. If necessary, repeat the operations above for several times;
5. Do not immerse into water. The surface of the kettle may be wiped over
with a damp cloth and polis
hed with a soft dry cloth.
6. Grasp the top of the scale filter and pull upwards to remove. Wash with
clean water and dry thoroughly before replacing in the kettle.
changed into heat preservation and then light up).
5.Press the heat preservation key three times, cancel the heat preservation,
turn on the lamp 1, turn off the heat preservation key lamp;
6.After pressing the start, the light flashes twice (two sounds at the same
time), and then remains on, after canceling, the power lamp goes out.
Press once again to cancel, stop heating/insulation, real-time display of
water temperature, enter standby.
7.Default key prompt sound, setting key and keep ware key combination
press, long sound, switch to button silent sound; Repeat combination key,
short sound, restore key prompt sound.
Note: Every triggering function button needs "drop" sound feedback, which
is not functional in the following cases.
8.Setting up 100
, pressing the heat preservation key has no function.
To Next Page
Loading...
Need help?
General
