Midea MLV45N1BWW User Manual

•
•
•
•
•
•
To fill your washer in the correct amount of time, the water pressure needs
to be between 14 and 116 psi (100 to 800 kPa).
The recommended height for the drain standpipe is 48 in. (122 cm).
The drain hose must be routed through the drain hose clip to the standpipe.
The standpipe must be large enough to accept the outside diameter of
the drain hose.
The water valve may fail or may not shut off completely.
The time it takes to fill your washer may be longer than the time your
washer controls allow. Your washer will turn off and report an error. A
time-limit is built into the controls to prevent flooding in your home if
a hose becomes loose.
Water inlet hoses must be purchased separately. You can buy inlet
hoses in various lengths up to 8 ft. (240 cm).
Make sure that the water faucets are easily accessible.
Turn off the faucets when you are not using your washer.
Periodically check to make sure that water is not leaking from the
water hose fittings.
14
Water requirements
Drainage requirements
To avoid the possibility of water damage:
If the water pressure is less than 14 psi (100 kPa):
Safety
Instructions
Features
Operation
Requirements
Installation
Instructions
Washer Use
Washer Care
Troublesho
o
ting

Midea MLV45N1BWW Specifications

General

Style	Top-Loading
Color	White
Washer Capacity	4.5 cu ft
Dryer Capactity	-
Max Spin Speed	700 RPM
Spin Speeds	5 (Extra High
Spin Class	E
Number of Cycles	10
Cycle Selections	Clean Washer With Affresh
Wash	Permanent Press
Options	Wash Temp
No spin and No heat	Soak Extra Rinse
Hours	Extra Rinse
Noise level	-
Temperature Selections	5 (Hot
Energy Class	-
Annual Energy Consumption	216 kWh
Annual Water Consumption	-
Water Consumption Per Cycle	-
Voltage	120 V
Frequency	60 Hz
Current	10 A

Weight and Dimensions

Depth	29 in
Height	46.2 in
Width	27 in
Net Weight	68 kg