Midea MLV45N1BWW User Manual

Connect the drain hose
Caution
5.
•
•
Do not overtighten the fittings or apply tape or sealant to the faucets
or water supply intakes. This can damage the fittings.
Make sure that the water supply hoses are not twisted or bent. A bent
or twisted hose can leak and cause an electric shock due to the water
leakage. To ensure the correct water usage, connect both hot and
cold water faucets. lf either or both are not connected, an error code
could occur.
Tighten the fittings by hand until they are snug, and then tighten them
an additional two-thirds of a turn with a wrench.
6. Turn on the hot and cold water supplies and check all the water supply
intake connections and the faucets for water leaks.
1. Find the end of the drain hose that has the clamp, then slide the clamp
away from the end of the hose.
Caution
Failure to slide the drain hose completely over the washer’s drain pipe
may result in water leakage.
Failure to move the clamp or hoop onto the washer’s drain pipe will
result in water leakage.
21
•
•
Safety
Instructions
Features
Operation
Requirements
Installation
Instructions
Washer Use
Washer Care
Troubleshooting

Midea MLV45N1BWW Specifications

General

Style	Top-Loading
Color	White
Washer Capacity	4.5 cu ft
Dryer Capactity	-
Max Spin Speed	700 RPM
Spin Speeds	5 (Extra High
Spin Class	E
Number of Cycles	10
Cycle Selections	Clean Washer With Affresh
Wash	Permanent Press
Options	Wash Temp
No spin and No heat	Soak Extra Rinse
Hours	Extra Rinse
Noise level	-
Temperature Selections	5 (Hot
Energy Class	-
Annual Energy Consumption	216 kWh
Annual Water Consumption	-
Water Consumption Per Cycle	-
Voltage	120 V
Frequency	60 Hz
Current	10 A

Weight and Dimensions

Depth	29 in
Height	46.2 in
Width	27 in
Net Weight	68 kg