BEFORE YOU CALL FOR SERVICE...
•
•
•
•
•
•
•
•
38
Troubleshooting Tips
Save time and money! Review the charts on the following pages first and
you may not need to call for service.
Problem Solutions
Washer does
not start
No water or
not enough
water
When washer
has excessive
vibration or
noise
Make sure that your washer is plugged in.
Make sure that the lid is closed.
Make sure that the water source faucets are open.
Make sure that you press the Start Pause button to
start your washer.
Before your washer starts to fill, it makes a series of
clicking noises to make sure that the lid is locked and
to do a quick drain.
Make sure that the Child Lock is not activated. See
Setting the child lock on page 34.
Make sure that the Delay option is not turned on. See
(Optional) Set a delaved start time on page 32.
Check the fuse or reset the circuit breaker.
Make sure that both faucets are fully turned on.
Make sure that the water pressure is in the range listed
in Water requirements on page 14.
Make sure that the water inlet hoses are not kinked.
Straighten if necessary.
Disconnect the hoses and clean the screens. The hose
filter screens may be clogged
Make sure that your washer is set on a level surface. If
the surface is not level, adjust your washer's feet to
level your washer.
Make sure that your washer is not touching any other
object.
Make sure that the laundry load is balanced.
During the spin process, if clothes are piled to one side
of the tub, your washer may stop because of the
imbalance. Your washer tries up to three times to solve
the probler automatically. If the washer cannot solve
the problem, try to manually redistribute clothes inside
the tub.
•
•
•
•
•
•
•
•
Safety
Instructions
Features
Operation
Requirements
Installation
Instructions
Washer Use
Washer Care
Troublesho
o
ting
To Next Page
Loading...
Need help?
General
Weight and Dimensions
