- Lift unit level and slide unit into wall sleeve until
firmly against front of wall sleeve and secure with
4 screws and washers (supplied in the SLEEVE
ASSEMBLY) through the unit flange holes.
(See Fig.7 and Fig.8)
- Reinstall front panel.(See Fig.9)
Place tabs over top rail A . Push Inward at bottom
until panel snaps into place B.
7.2 Care and cleaning
• FRONT PANEL AND CASE
- Turn unit off and disconnect power supply. To
clean, use water and a mild detergent. Do not use
bleach and abrasivers. Some commercial cleaners
may damage the plastic parts.
• OUTDOOR COIL
- Coil on outdoor side of unit should be checked
regularly. Unit will need to be removed to inspect
dirt build-up that will occur on the inside of the coil.
If clogged with dirt and soot ,coil should be
professionally cleaned. Clean inside and outside of
outdoor coils regularly.
NOTE: Never use a high-pressure spray on coil.
www.mideaaircon.com
19
To Next Page
Loading...
Need help?
General
