8
Using the remote control
There are five function buttons on remote control, function are as
follows:
SYMBOL FUNCTION
Display & function ON/OFF
Heating mode: HIGH/LOW
Timer setting
Increase the temperature and timer setting
Decrease the temperature and timer setting
The remote control function is same as the button on the heater body, it
allows you to operate easily. When using remote control, it should be
aimed at receiving window of the unit, effective distance is around 6
meters.
If the remote control does not operate the unit when pointed directly at it,
replace the battery.
a) Open the cover, remove the old battery and replace with the same
battery type. Always observe the correct polarity when installing the
battery.
b) Do not mix new and old batteries.
c) Replace a battery immediately once it is exhausted to prevent
leakage.
d) Remove the battery if the remote control is not used for long periods.
e) Do not attempt to recharge non-rechargeable battery.
f) Do not dispose of the battery in a fire as they may explode.
TROUBLE SHOOTING
If your heater fails to operate, please follow these instructions:
1. Ensure that your circuit breaker or fuse is working properly.
2. Be sure the heater is plugged in and that the electrical outlet is
working properly.
3. Check for any obstruction. If you find any obstruction, turn the heater
off. Unplug the heater and wait a few minutes for it to cool down.
Carefully remove the obstruction.
4. Plug the heater in and turn it on again by referring to the OPERATING
INSTRUCTION.
To Next Page
Loading...
Need help?
General
