13
CLEANING AND MAINTENANCE
To avoid accident, cut o the power supply before operation according
to the following instructions.
1. The machine had been disinfected before departing from factory. Clean the
Clean the dispenser prior to installing a full bottle of water for the fist time.
2. Cleaning and draining instruction:
1) Before cleaning, make sure the power switch in the O(o) position and
unplug the water dispenser.
2) Vertically insert the bottle into the supporter on tap of the machine.
3) Open the taps, let about 3 liter water flow into a container.
4) Remove the water bottle from the dispenser.
5) Place a large bucket beneath the drain outlet. Remove the drain cover
and allow water to drain.
6) After draining, replace the drain cover and you can use the machine.
Attention: The dispenser heats water to a temperature of approximately 85 °C.
It can cause severe burns. Please operate it carefully.
3. Sanitizing
The machine should be disinfected with a disinfectant according to the instruction
manual of the disinfectant and then clean it with water(see cleaning and draining
instruction) Generally this should be done every three months.
4. To Remove Mineral Deposits:
Mix 4 liters water with 200g citric acid crystals, inject into the machine and make
sure the water can flow out of the hot water tap. Switch on the power and heat it
about 10 minute. 30 minutes later, drain o the liquid and clean it with water two
or three times. Generally this should be done every six months.
Never disassemble this machine by yourself to avoid danger from damaging
machine.
To Next Page
Loading...
Need help?
General
