Miele B 1847 User Manual

Fan
The fan on the ironing table is
controlled with the o, p or n, m
buttons.
B 1312 only:
The blow function is activated by the o
button.
The suction function is activated by the
p button.
B1826 and B 1847 only:
You can switch between the blow and
suction functions with a single press on
the n button.
You can switch between the two power
output levels with a single press on the
m button.
Power setting1=1fanactive
Power setting2=2fans active
The fan/s are located on the underside
of the ironing table.
Suction function
The suction function assists steam
permeation of textiles, avoids the
formation of condensation on the
ironing table and holds the item so that
it does not slip off the ironing table.
Blow function
The blow function creates a cushion of
air between the textile and the ironing
table and helps prevent seams being
pressed into the garment. It also assists
with ironing frills, sequins, etc and
allows you to iron without flattening the
fabric.
Automatic switch on/off
Automatic switch on/off ensures that the
fan starts at exactly the right time when
using steam.
After a short running-on time the fan
stops automatically, because the fan is
not needed during pauses in ironing,
e.g. when the textiles are being folded.
Memory function
The memory function saves the
last-used fan direction and power
setting.
Heated ironing surface
When the appliance is switched on, the
ironing surface will heat up
automatically, helping to reduce the
formation of condensation on the
ironing table.
Ironing
32

Miele B 1847 Specifications

General

Iron power	- W
Product color	Black, White
Soleplate type	-
Water tank capacity	1.25 L
Maximum steam pressure	4 bar
Steam boost performance	- g/min
Vertical steam function	Yes
Continuous steam performance	100 g/min
Connected load	2200 W