Switching on the Fashion
Master
^
Press the On/Off button s.
The ring around the s button lights up
yellow.
The Fashion Master starts heating up.
Steam can escape from the iron during
the heating-up phase.
During operation pumping, boiling and
knocking noises may be heard.
These are normal noises which occur
during operation.
When the appliance is ready and steam
is available, the * indicator light comes
on.
Depending on how long the Fashion
Master has been used for, an automatic
rinse (see "Automatic rinsing") or
automatic descaling (see "Automatic
descaling") may be carried out
immediately after it is switched on.
The appliance cannot be used whilst
the rinsing or descaling processes
are running.
Filling the water container
If the water container is empty or not
inserted into the system, the k indicator
light comes on.
^ Remove the water container. Hold the
container by the integral handle, then
pull it out and upwards to remove it.
The water container can drip a little
when it is being removed until the
container valve closes. Removing the
water container slowly can prevent it
from dripping.
Switching on
23
To Next Page
Loading...
Need help?
General
