en
36
Preparing for use
Attach the suction hose (dia. 01)
Insert the hose connector into the
suction socket on the vacuum
cleaner until it clicks into position. To
do this, line up the guides on the two
pieces.
To detach the suction hose (dia. 02)
Press the release buttons at the side
of the hose connector, and lift the
hose from the socket.
Connect the suction hose to the
handle (dia. 03)
Fit the connector at the other end of
the suction hose into the handle until
it clicks into position.
Your vacuum cleaner is fitted with one
of the following suction tubes, depend-
ing on model:
– EasyLock suction tube
– Telescopic suction tube
– Comfort telescopic suction tube
To assemble the EasyLock tube
(dia. 04)
Hold the suction tube by the connec-
tion piece and push it into the second
suction tube, turning it clockwise or
anti-clockwise until it clicks into posi-
tion.
Slide the connection piece upwards
until it clicks into position.
Connect the handle to the suction
tube (dia. 05 + 06)
Insert the handle into the suction
tube until it clicks into position. To do
this, line up the guides on the two
pieces.
To detach the handle
To detach the handle from the suc-
tion tube, press the release button
and pull the handle out of the suction
tube, twisting it slightly as you do so.
Adjusting the telescopic suction tube
(dia. 07)
One part of the telescopic tube is
packed inside the other, and it can be
adjusted to suit your height for comfort-
able vacuuming.
Press the release button and adjust
the tube to the desired height.
Adjusting the Comfort telescopic
suction tube (dia. 07)
One part of the Comfort telescopic tube
is packed inside the other, and it can be
adjusted to suit your height for comfort-
able vacuuming.
Grasp the release mechanism and
adjust the telescopic suction tube to
the required length.
Connect the suction tube to the
floorhead (dia. 08)
Push the suction tube into the floor-
head and turn it clockwise or anti-
clockwise until it clicks into position.
To Next Page
Loading...
Need help?
General
