Miele Complete C2 Tango EcoLine User Manual

en
43
If you wish to fit anAirClean
Plus50,Active AirClean 50 or an
HEPA AirClean 50 filter, see “Repla-
cing one type of exhaust filter with
another”.
 Close the filter grille.
 Close the dust compartment lid.
Replacing the AirClean Plus 50,
Active AirClean 50 and
HEPA AirClean 50 exhaust filters
(dia. 36 + 37)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter, making it
sure it goes in properly, then press it
down into position.
 If you are using exhaust filter c or d,
press the exhaust filter TimeStrip®
change indicator (dia. 15).
After approx. 10 - 15 seconds, a thin
red line will appear in the left hand side
of the display (dia. 16).
If you wish to fit anAirClean filter,
see “Replacing one type of exhaust
filter with another”.
 Close the dust compartment lid.
Replacing one type of exhaust filter
with another (dia. 12)
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean
b AirClean Plus 50 (light blue)
c Active AirClean 50 (black)
d HEPA AirClean 50 (white)
Do not use more than one exhaust fil-
ter at a time.
When changing the filter, please note
1. If you wish to replace exhaust filter a
with filter b, c or d, it is essential that
you remove the filter grille before you
fit the new exhaust filter.
If you are using exhaust filter c or d,
you must also activate the exhaust
filter TimeStrip® change indicator
(dia. 15).
2. If you wish to replace exhaust filter b,
c or d with filter a it is essential that
this filter is fitted in the filter grille *
(dia. 35).
* Filter grille - see “Optional ac-
cessories”
Replacing the thread lifters
(dia. 38 + 39)
(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Replace
the thread lifters if the pile has worn
down.
 Lever the thread lifters from the slots.
To do so use a suitable tool, e.g. a flat
blade screwdriver.
 Fit new thread lifters.

Miele Complete C2 Tango EcoLine Specifications

General

Proper use	Home
Noise level	78 dB
Cleaning surfaces	Carpet, Hard floor
Vacuum air filtering	Miele AirClean
Dirt separating method	Filtering
Motor protection filter	Yes
Power control	Electronic
Maximum input power	800 W
Annual energy consumption	28 kWh
Type	Cylinder vacuum
Cleaning type	Dry
Dust capacity	4.5 L
Product color	Red
Tube material	Stainless steel
Tube lock type	Click
Dust container type	Dust bag
Cord length	6.5 m
Control type	Rotary
Vacuum brushes included	Dusting brush