Drip tray
The trip tray contains a sensor which
causes the display to show when the
tray is full and needs to be emptied.
Clean the drip tray daily.
Remove the drip tray after the final
rinse when no more water runs from
the lines.
Carefully remove the drip tray from
the machine; the water may be very
hot and could cause scalding.
^ Open the door and pull the drip tray
out.
The drip tray contains a grid to avoid
spilling during transport.
^
Wash the drip tray and grid in the
dishwasher or by hand with hot water
and liquid dish soap, then dry with a
soft cloth.
Take care that the metal contacts at
the back of the drip tray are clean
and dry. If the contacts are soiled or
wet the unit cannot detect when the
drip tray is full and needs to be
emptied.
^ Push the drip tray with grid along the
right edge all way in the machine.
^ Close the door.
Drip tray cover
^
Remove the drip tray cover and wash
it.
Cleaning and care
48
To Next Page
Loading...
Need help?
General
