Installation
101
Installing the coffee system
Make sure that there is no power to
the machine during installation. This
also applies when uninstalling.
The machine may only be operated
when installed and in an ambient
temperature range between +50°F
(10°C) to +100°F (38°C).
For installation, you will require two
socket wrenches in sizes 3 and 5.
To ensure the appliance door is flush
with the cabinetry front, a seal around
the building-in niche is needed or a
sealing strip must be adhered to the
coffee system.
If there is not a seal at the front of the
building-in niche, adhere the Miele
sealing strips from the back (see pic-
ture) before installing the coffee sys-
tem.The sealing strips can be pur-
chased from Miele.
Sealing strips are available from your
Miele dealer or from Miele.
Tip: We recommend providing a place
to sit the coffee system which is the
same height as the building-in niche.
This will make it easier to connect the
machine to the electrical supply and
water line.
Using the large allen key, unscrew all
four feet out by about 3/4" (2mm).
The feet can be unscrewed by up to
approx. 4" (10mm).
Connect the appliance to the water
intake hose (see "Plumbing").
Connect the appliance to the electri-
cal supply.
Ensure the electrical and water con-
nection does not get damaged when
pushing the appliance into the niche.
Push the coffee system all the way
into the building-in niche.
Make sure the coffee system is cen-
tered and straight in the building-in
niche. If this is not the case, align the
machine using the four bases.
The appliance comes with four M5
socket screws to help you align and se-
cure it in the building-in niche.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
