Plumbing
95
Parts must only be replaced with
original Miele spare parts, available
from Miele.
Fitting the stainless steel hose
to the appliance
Make sure that the stainless steel
hose is not kinked or damaged. The
stainless steel hose must not be
shortened.
Remove the water connection cover
from the bottom of the back panel of
the machine.
Take the angled side of the stainless
steel hose and check whether a gas-
ket is present. If not, insert one.
Screw the stainless steel hose cou-
pling nut onto the threaded union.
Ensure that the hose is correctly fitted
and that it is water-tight.
Connecting to the water supply
Before establishing the fixed network
connection, ensure the appliance is
disconnected from the electrical sup-
ply.
Connection to the water supply should
be carried out by a qualified plumber
and should incorporate a connection
with a 3/8" thread.
Check that the gasket is present. Re-
place, if not, insert before connecting
to the water supply.
Screw the supplied brass compres-
sion fitting, with the 3/8" end, tightly
onto the water connector of the cof-
fee machine. (Tighten the compres-
sion fitting by hand, do not use a
tool.) The fitting includes an opening
for standard 1/4" piping.
Old or used hoses must not be con-
nected to this coffee system.
Connect the compression fitting to
the water supply.
Slowly open the shut-off valve to the
water supply and check for leaks.
If necessary, check whether the seal-
ing ring and fittings are tight.
You can now continue with the installa-
tion of the coffee system in its housing
unit (see "Installation").
To Next Page
Loading...
Need help?
General
Weight and Dimensions
