The dishwasher does not fill/drain
Problem Possible cause Remedy
The dishwasher
stops working
shortly after the start
of the programme.
The buzzer sounds.
The Inlet/Drain check
indicator flashes
when the door is
opened.
The stopcock is
closed.
–
Open the stopcock fully.
The dishwasher
stops during a
programme.
The buzzer sounds.
The Inlet/Drain check
indicator flashes
when the door is
opened.
Before rectifying the problem you
must:
– Switch the dishwasher off with the
Off button o.
Water intake is
restricted.
– Open the stopcock fully.
– Clean the water inlet filter (see
"Problem solving").
– The water pressure at the intake is
lower than 30 kPa (0.3 bar).
Seek professional advice.
Water outlet is
restricted, water
remains in the
wash cabinet at
the end of a
programme.
– Clean the filter combination. See
"Cleaning and Care".
–
Clean the drain pump. See
"Problem solving".
–
Clean the non-return valve. See
"Problem solving".
–
Remove any kink in the drain
hose.
Problem solving guide
42
To Next Page
Loading...
Need help?
General
