Miele G 1180 Vi User Manual

Factory default setting
If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^
Open the door.
^
Switch the dishwasher off with the Off
button o.
^
Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the On
button g.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the programme selector button
briefly 12 times.
The "Inlet/Drain" check light will give
one long flash and two brief flashes at
intervals.
The upper right hand indicator shows
whether a setting other than the factory
default setting has been set.
–
If the upper right hand indicator is
flashing:
All settings are factory default
settings.
–
If the upper right hand indicator is
not lit up:
At least one setting has been altered
from the factory default setting.
^
If you want to re-set the factory
default settings, press the
programme selector button for at
least one second until the "Inlet/Drain"
check light comes on.
^ Press the programme selector button
briefly.
The setting is now stored in memory.
^ Switch the dishwasher off with the Off
button o.
Operation
35

Miele G 1180 Vi Specifications

General

Brand	Miele
Model	G 1180 Vi
Category	Dishwasher
Language	English