General problems
Problem Possible cause Remedy
Detergent residue is
left in the dispenser at
the end of a
programme.
The dispenser was still
damp when detergent was
added.
Make sure the dispenser is
dry before adding
detergent.
The detergent lid
cannot be closed
properly.
Clogged detergent residue
is blocking the catch.
Clean the detergent from
the catch.
At the end of a
programme there is a
film of moisture on
the inside of the door
and the interior walls.
This is caused by the
drying system and does not
indicate a fault.
The moisture will dissipate
after a short while.
Water remains in the
wash cabinet at the
end of a programme.
Before rectifying the
problem you must:
– Switch the dishwasher
off with the Off button
o.
The filter combination in the
wash cabinet is clogged.
Clean the filter
combination. See
"Cleaning and Care".
The drain pump or
non-return valve may be
blocked.
Clean the drain pump or
the non-return valve. See
"Problem solving".
The drain hose is kinked. Remove any kink from the
drain hose.
Problem solving guide
43
To Next Page
Loading...
Need help?
General
