Factory default setting
If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^
Open the door.
^
Switch the dishwasher off using the
Off button o.
^
Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the On
button g.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Tab button twelve times.
The "3 in 1 Tab" indicator will give one
long flash and two brief flashes at
intervals.
The characters flashing in the Display
show whether a setting other than the
factory default setting has been set.
–
"p 1": All settings are set to factory
default settings.
–
"p 0": At least one setting has been
changed.
^
To reset to the factory default
settings, press the programme
selector button.
The setting is now stored in memory.
^
Switch the dishwasher off using the
Off button o.
Operation
39
To Next Page
Loading...
Need help?
General
