Water softener
To set the water softener
Water hardness level of 20-630 mg/l
(1 - 35 °d German scale):
Switch the dishwasher off.
Use a screwdriver to remove the lid
of the water hardness level selector
in the wash cabinet.
Check that the selector is set to set-
ting 6 (factory setting). If not, use a
flat blade screwdriver or a coin to
turn the selector until it clicks on set-
ting 6.
Turn the programme selector switch
to the “STOP” position.
Press the“Delay start” and “START”
buttons
at the same time and at the
same time switch the dishwasher on
by pressing the “On/Off”-button.
A “P” and a figure appear in the time
display.
Set the programme selector switch
to the “UNIVERSAL 55 °” position.
A figure appears in the time display
corresponding to the water hardness
level already set, e.g. "22" - the water
softener is set to a water hardness
level of 400 mg/l (22 °d German
scale).
Press the “Top Solo” button as often
as necessary until the value of your
water hardness appears in °d in the
time display.
Example:
For a water hardness level of 540 mg/l
(30 °d German scale).
Keep pressing the “Top Solo” button
until “30” appears in the time display.
Once the figure “36” is reached the
counter returns to “0”.
Value “0” must not be set!
Press the “START”-button x 2.
The change is stored in memory;
the length of time of the selected pro-
gramme appears in the time display
again.
Water softener
15
To Next Page
Loading...
Need help?
General
