Water softener
Salt indicator
When the salt reservoir is empty the
“Salt” indicator light comes on. The
reservoir should be refilled with dish-
washer salt for reactivation.
After the reservoir has been refilled with
salt the water softener is automatically
reactivated either the next time the dish-
washer is run or the time after that.
The “Reactivate” indicator light illumi-
nates during this process.
Note
The salt indicator light will come on if
the water used is very soft, i.e. con-
stantly at a level below 70 mg/l (4 °d).
The salt reservoir is empty as no reacti-
vation salt is needed with such soft
water.
The light is of no significance in this
case.
The "Salt" indicator light has also been
designated for future programme up-
dates, (see "After Sales Service").
Water softener
18
To Next Page
Loading...
Need help?
General
