Cleaning the spray arms
Waste particles can lodge in the spray
arm jets.
The spray arms should be inspected
and cleaned regularly (approx. every
6 months).
^
Use a sharp pointed object to push
particles into the spray arm jets and
rinse well under running water.
Remove the spray arms as follows:
^
Unscrew the upper spray arm.
^
Remove the middle spray arm (on
the top basket) by unscrewing the
toothed wheel mechanism.
Important:
The toothed wheel mechanism has a
left hand thread, and to unscrew it, it
must be turned to the right with the
spray arm.
^
First remove the bottom basket and
then take the lower spray arm out.
Particles in the lower spray arm are
easier to rinse out if the cap is first
opened.
^ Open the cap in the direction of the
arrow. After cleaning close up the
cap again.
^ After replacing the spray arms check
that they move freely.
Cleaning and care
39
To Next Page
Loading...
Need help?
General
