Water in the wash cabinet is not
heated; the program sequence lasts
too long
This machine has a resettable heater
limiter which will turn off the heaters in
the case of over-heating. This could be
caused for example, if large articles
obscure the heating elements or if the
filters in the wash cabinet are blocked.
^
Remove the cause of the fault.
^
Remove the service panel (see
"Electrical connection").
^
Press the reset button on the heater
limiter (yellow) located on the left-
hand side of the plastic cover.
If this switch trips again contact
Miele.
Frequently Asked Questions
43
To Next Page
Loading...
Need help?
General
